Maintenance Instructions; Lubrication Instructions; Cleaning - Cobra RM46SPH Owner's Manual

6.9 HEIGHT ADJUSTMENT INSTRUCTIONS
CAUTION: Do not at any time make any adjustment to lawnmower without first stopping the engine and
disconnecting the spark plug wire.
CAUTION: before changing the mowing height, stop the mower and disconnect spark plug cable.
Your mower is equipped with a central height adjustment lever offering 6 height positions.
Fig.10A Position 1: 17mm; Fig.10B Position 6: 75mm.
Fig.10A
1. Stop mower and disconnect the spark plug cable before changing the mower cutting height.
2. The central height adjustment lever offers you 6 different height positions.
3. To change the height of cut, pull the adjuster lever away from the engine out of the slots and then move
either up or down to select the required height of cut. Push the lever back into the slot to secure.

7. MAINTENANCE INSTRUCTIONS

SPARK PLUG
Use only the original replacement spark plug. For best results, replace the spark plug every 100 hours of use.
8. LUBRICATION INSTRUCIONS
CAUTION: DISCONNECT THE SPARK PLUG BEFORE SERVICING.
1. WHEELS-Lubricate the ball bearings in each wheel at least once a season with a light oil.
2. ENGINE-Follow engine manual for lubrication instructions.

9. CLEANING

CAUTION: Do not hose the engine. Water can damage the engine or contaminate the fuel system.
1. Wipe deck with dry cloth.
2. Hose under the deck by tilting the mower, so that the spark plug is up.
9.1 ENGINE AIR FILTER CLEANER
CAUTION: Do not allow dirt or dust to clog the air filter foam element. The engine air cleaner element must be
serviced (cleaned) after 25 hours normal mowing. The foam element must be serviced more frequently if the
mower is used in dry and dusty environments.
TO CLEAN THE FOAM AIR FILTER:
1. Lift the tabs on top of the filter cover and remove the cover.
2. Wash filter element in soap and water. DO NOT USE PETROL!
3. Air dry the filter element.
4. Place a few drops of SAE30 oil on the foam filter and squeeze tightly to remove any excess oil.
5. Reinstall the filter.
FOR PAPER CARTRIDGE FILTERS – CHECK & REPLACE AS NECESSARY
Fig.10B
- 13 -