Installing The Chuck; Adjusting The Drive Belt; Head To Column; Pulley Cover Knob - Central Machinery 38119 Set Up And Operating Instructions Manual

5-speed drill pres

Hide thumbs Also See for 38119:

Set up and operating instructions manual (19 pages)

Table Of Contents

Table of Contents

Slide the Table Support with Table over the Column (#11) and secure at a convenient position by

tightening the Table Support Locking Handle.

It may be necessary to unscrew the Head Lock Set Screws (#3) slightly to ensure they do not pro-

trude internally, as this will prevent the head from sliding fully into position.

With assistance, raise the Head and place it on top of the Column, ensuring it slides home fully.

Align the head with the base (#7), and firmly secure with the Head Lock Set Screws (#3).

Screw the three Feed Handles (#15) firmly into the hub of the Feed Shaft.

With the Chuck Guard lifted clear of the spindle nose, slide the work table up the column to within

6" of the spindle.

Open the jaws of the chuck to their maximum, using the Chuck Key supplied.

Put a piece of scrap wood on the table to protect the Chuck Nose.

Ensuring all parts are thoroughly clean and dry and burr free, place the chuck over the end of the

spindle, and pull the spindle down using the feed handles, pressing the chuck jaws hard against the

piece of scrap wood until the chuck is forced home.

Locate the knob with pan head screw and attach to the cover.

Screw on tightly.

The drive belt is pre-installed. However, if the belt requires tightening or the spindle speed needs to

be changed, proceed with the following steps:

Undo the Belt Tension Locking Screw to loosen the belt.

Consult the chart inside the pulley cover (or the Drill Speed chart in this manual), and install the belt

in the position corresponding to spindle/drill speed required.

Lever the motor, on its bracket, away from the head, so that tension is applied to the belt. Tension

is correct when the belt deflects by approximately 1/2" at its center when using reasonable thumb

pressure. Lock the motor in this position using the locking screw.

note: If the belt slips during operation, adjust the belt tension.

SKU 38119

For technical questions, please call 1-800-444-3353.

Head to column