Extron electronics SW2 VGA Ars User Manual page 23

Sw vga / ars series
Hide thumbs Also See for SW2 VGA Ars:
Table of Contents

Advertisement

Remote Control, cont'd
3.
If you have not updated firmware for the SW VGA switcher
before, on the Add Device screen, select the RS-232 tab.
If you have updated firmware for this model, click Cancel.
The Firmware Loader window appears. Proceed to step 6.
Figure - — A
Although the screen also has a TCP/IP tab, the switcher
does not have a LAN port. Do not select the TCP/IP tab.
4.
From the drop-down menus on the RS-232 screen, select the
appropriate Com port number (obtained from your system
administrator) and baud rate (the default is 9600).
.
Click OK. The Firmware Loader window appears.
Figure - —
tron Fir ware oa er win ow
Select the SW VGArs and click File > Open. The Choose
6.
Firmware File screen appears.
SW VGArs / Ars Series Switchers • Remote Control
4-12
e ice screen
.
Navigate to and select the new firmware file. The Choose
Firmware File window closes.
When downloaded from the Extron Web site, the firmware
is placed at C: Program Files\Extron\Firmware\SW .
CAUTION
The firmware file must have a .s19 extension. Other
file types can cause the switcher to stop functioning.
Figure -1 — hoose Fir ware File win ow
In the Firmware Loader window, click Begin.
.
The Total Progress and Progress status bars show the
progress of the upload. The firmware upload to the
switcher may take several minutes. Once the status bars
have progressed from 0% to 100%, and Status is listed
as Complete, the firmware loader utility resets the switcher.
Figure -11 —
tron s Fir ware oa er screen
.
Click Exit to close the Firmware Loader.
SW VGArs / Ars Series Switchers • Remote Control
4-13

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sw4 vgarsSw6 vgarsSw6 vga arsSw4 vga arsSw2 vgars

Table of Contents