Table of Contents
Advertisement
Connecting External Components
1
Connect the elite Panaboard to a computer using the USB cable.
• Plug the USB cable into a USB port on the computer.
Notice
• Do not connect the elite Panaboard to a computer via USB unless elite Panaboard driver/
software/book is installed.
Only connect the USB cable after following the steps in "Installing the Software" (page 19) to
install the software.
To USB Port
* In the case of the UB-T580, the length of the USB cable from the edge of the main unit is approx.
2.7 m (8 ft. 10
5
/
in.) when it is connected to the left side and approx. 2.4 m (7 ft. 10
16
connected to the right side.
In the case of the UB-T580W, the length is reduced by about 15 cm (5
2
Connect the computer to a projector.
• For instructions on connecting your computer and projector, refer to the respecting instruction
manuals.
About the Usage Location
• Do not place the elite Panaboard where it is directly exposed to sunlight.
• Do not use the elite Panaboard in a location less than 10
changes in temperature.
Note
• The elite Panaboard may not work properly when used in one of the above locations.
USB Cable*
Computer
AC
Video Cable
Projector
7
/
in.) each on both sides.
8
°
°
C (50
F) or in a location subject to extreme
Usage
1
AC
1
/
in.) when it is
2
17
Hide quick links:
Advertisement
Table of Contents
