Installing Rf Dongle; Registering Magic Motion Remote Con- Trol; How To Use Magic Motion Remote Con- Trol - LG 32LV3710-TB Owner's Manual

34
REMOTE CONTROL

Installing RF Dongle

(Only 32/37/42/47/55LV37 ** ,
32/37/42/47/55LV55 ** , 32/42/47/55LW57 ** ,
42/47/55/65LW65 ** )
Image shown may differ from your TV.
1
Locate the designated Velcro attachment
location on the TV. Then tear off the protection
paper and attach the Velcro. (The attachment
location is different depending on the TV model
you own)
Velcro
* Attach the RF dongle aligning with the upper left
corner bracket.
2
Connect the RF Dongle Cable plug on the RF
Dongle to a USB jack on the TV.
3
Attach the RF Dongle to the velcro as shown
below and then turn on the TV.
* If the RF dongle for the wireless media box is attached,
attach the RF dongle for the Magic Motion remote
control on the upper right of the back of the TV.
* To avoid wireless interference, keep the distance
between the RF dongle for the Magic Motion remote
control and the Wi-Fi dongle at 20 cm.
NOTE
Separate purchase : 32/37/42/47/55LV37 ** ,
y
32/37/42/47/55LV55 ** , 32/42/47/55LW57 **
(This feature is not available for all country.)
or
RF Dongle
20 cm
Registering Magic Motion Re-
mote Control
The Magic Motion Remote Control operates by
pairing with your TV.
Register the Magic Motion Remote Control to use.
How to register the Magic Motion Remote
Control
To register the remote control, press the OK button
on the remote control while aiming it at your TV.
How to Re-register the Magic Motion Remote
Control after Registration Failure
Reset the remote control by pressing and holding
both the OK and MUTE buttons for 5 seconds.
(Once the reset is complete, the light on the
Pointer blinks.) Then repeat the above procedure
to register the remote control.
How to use Magic Motion Re-
mote Control
1
Press OK button if there is no pointer on your
TV screen. The pointer will then appear on the
screen.
If the pointer has not been used for a certain
period of time, it will disappear.
2
You can move the pointer by aiming the Pointer
Receiver of the remote control at your TV then
move it left, right, up or down.
If the pointer does not work properly after click-
ing the OK button, leave the remote control for
10 seconds then use it again.