TG862xAZ(e).book Page 46 Thursday, May 12, 2011 1:39 PM
Answering System
Important:
L In order to operate the answering
system remotely, you must first set a
remote access code.
1
1 (middle soft key) y3z6
2
To turn on remote operation, enter
the desired 3-digit remote access
code.
3
M s {ic}
Deactivating remote operation
Press * in step 2 on "Remote access
code", page 45.
L The entered remote access code is
deleted.
Using the answering system
remotely
1
Dial your phone number from a
touch-tone phone.
2
After the greeting message starts,
enter your remote access code.
3
Follow the voice guidance prompts
as necessary or control the unit
using remote commands (page 46).
4
When finished, hang up.
Voice guidance
During remote operation, the unit's voice
guidance starts and prompts you to
press 1 to perform a specific operation,
or press 2 to listen to more available
operations.
Note:
L If you do not press any dial keys within
10 seconds after a voice guidance
prompt, the unit disconnects your call.
Remote commands
You can press dial keys to access
certain answering system functions
46
without waiting for the voice guidance to
prompt you.
Key
Operation
Repeat message
1
*1
(during playback)
Skip message
2
(during playback)
Play new messages
4
Play all messages
5
Play greeting message
6
Record greeting message
7
Stop recording
9
Stop playback
Turn answering system off
z
Erase currently playing
*4
message
Erase all messages
*5
Reset to a pre-recorded
*6
greeting message (during
greeting message playback)
End remote operation
*y
(or hang up)
*1 If pressed within the first 5 seconds of
a message, the previous message is
played.
Turning on the answering
system remotely
If the answering system is off, you can
turn it on remotely.
1
Dial your phone number from a
touch-tone phone.
2
Let the phone ring 15 times.
L A long beep is heard.
3
Enter your remote access code
within 10 seconds after the long
beep.
L The greeting message is played
back.
L You can either hang up, or enter
your remote access code again