Assembling Your Tilt-Head Stand Mixer - KitchenAid 5KSM150PS Manual To Expert Results

Assembling Your Tilt-Head Stand Mixer

To Attach Bowl
1. Turn speed control to "O."
2. Unplug stand mixer or disconnect
power.
3. Hold the locking lever in the UNLOCK
position and tilt motor head back.
4. Place bowl on bowl clamping plate.
5. Turn bowl gently in clockwise direction.
To Remove Bowl
1. Turn speed control to "O."
2. Unplug stand mixer or disconnect
power.
3. Hold the locking lever in the UNLOCK
position and tilt motor head back.
4. Turn bowl counterclockwise.
To Attach Flat Beater,
Wire Whip, or Dough Hook
1. Turn speed control to "O."
2. Unplug stand mixer or disconnect
power.
3. Hold the locking lever in the UNLOCK
position and raise motor head.
4. Slip beater onto beater shaft and press
upward as far as possible.
5. Turn beater to right, hooking beater
over pin on shaft.
To Remove Flat Beater,
Wire Whip, or Dough Hook
1. Turn speed control to "O."
2. Unplug stand mixer or disconnect
power.
3. Hold the locking lever in the UNLOCK
position and raise motor head.
4. Press beater upward as far as possible
and turn left.
5. Pull beater from beater shaft.
To Lock Motor Head
1. Make sure motor head is completely
down.
2. Place locking lever in LOCK position.
3. Before mixing, test lock by attempting
to raise head.
To Unlock Motor Head
1. Place lever in UNLOCK position.
Pin
NOTE: Motor head should always be kept
in LOCK position when using mixer.
O
To Operate Speed Control
Plug mixer in proper electrical outlet.
Speed control lever should always be
set on lowest speed for starting, then
gradually moved to desired higher speed
to avoid splashing ingredients out of bowl.
See "Speed Control Guide - 10 Speed
Mixers" section.
5
1 2 4 6 8 10