CEN-TECH 67855 Set Up And Operating Instructions Manual page 8

unpacKing
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
on the cover of this manual as soon as
possible.
assembly
1. Place the Battery Charger/Starter on
its side.
2. Use two Screws (10) to install the
Mounting Foot (5) to the front bottom
of the Charger/Starter. See Figure 2,
below.
Wheel
(3)
Screws
(10)
Mounting
Foot (5)
Figure 2
3. Slide the Wheels (3) onto the ends of
the Axle (4) and slide an Axle Cap (6)
onto each wheel. If necessary, tap on
the Axle Caps with a rubber mallet.
nOte: Verify the Hub of each Wheel
is facing in. See Figure 1, above.
4. Set the Axle along the bottom of the
Charger/Starter and Align the Axle
Brackets (7) with the mounting holes.
Once aligned, fasten the Wheel Axle
into place. See Figure 1, above.
Page 8 For technical questions, please call 1-800-444-3353.
5.
6.
Axle (4)
7.
Axle
Bracket
(7)
Axle Cap (6)
Stand up the Charger/Starter.
Remove the two top screws on each
side of the Charger/Starter and set
the Handle against the back of the
unit, aligning the mounting holes.
See Figure 2, left.
Figure 3
Use the Screws (9) to mount the
Handle (2) to the back of the Charger/
Starter (1). See Figure 3, above.
Handle
(2)
Screw
(9)
Battery
Charger (1)
SKU 67855