Maintenance And Troubleshooting - CEN-TECH 67855 Set Up And Operating Instructions Manual

6/12v battery charger/starter
Table of Contents

Advertisement

maintenance and trOuBleshOOting

Warning: unplug the charger/starter from its electrical outlet before performing
any inspection, maintenance, or cleaning procedures.
1.
Before each use, inspect the general condition of the Battery Charger/Starter.
Check for loose screws, cracked or broken parts, damaged electrical wiring, and
any other condition that may affect its safe operation. If abnormal noise occurs,
have the problem corrected before further use. Do not use damaged equipment.
2.
Periodically recheck all nuts, bolts, and screws for tightness.
3.
After each use, wipe down the Cable Clamps and apply a light grease.
4.
Store in a clean and dry location.
problem
Ammeter display reads
maximum.
No ammeter reading.
Charging current not to
full output.
Ammeter needle
moves up to full
charge, then drops to
zero. Makes "clicking"
noise.
Follow all safety precautions whenever diagnosing or servicing the
tool. disconnect power supply before service.
SKU 67855
For technical questions, please call 1-800-444-3353.
troubleshooting
possible causes
Defective battery.
1.
No power to engine starter.
2.
Battery cables not making
connection.
3.
Two-amp charge rate being
used.
1.
Battery is partially charged.
2.
Defective battery, will not hold
full charge.
1.
Battery is completely dead.
2.
Defective battery.
3.
Charge Engine Starter is
resetting itself after circuit
overload.
4.
Circuit breaker is cycling.
5.
Reverse connections at
battery.
likely solutions
Check or replace battery.
1.
Check power and cable outlet
connections.
2.
Clean battery cables and reset cable
clamps.
3.
None, meter will not indicate here.
1.
Continue charging battery.
2.
Check and/or replace battery.
1.
Continue charging battery. Charge Engine
Starter will continue to reset itself until the
battery reaches a chargeable level.
2.
Check and/or replace battery.
3.
Wait until Charger automatically resets
itself.
4.
May be the wrong switch position.
5.
Shut off charger and correct cable lead
connections.
Page 13

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents