Denon AVP-A1HDCI Owner's Manual page 17

Record Player
CD Player
I
Use a DENON Control Dock for iPod (ASD-l R, sold separately) to
connect the iPod to the AVP-A1HDCI. For instructions on the Control
Dock for iPod settings, refer to the Control Dock for iPod's operating
instructions.
Example:
t?-
o
With the default settings, the iPod can be used connected
to
the
VCR (;Pod) connector
o
To assign the iPod to a connector other than VCR (;Podl, make the
settings at GUI menu "Source Select" - "(input source to which
iPod dock assignedl" - "Assign" - "iPod dock" ((1f"page 47)
COAXIAL
OUT
XLR
OUT
L R
00
- - - - AUDIO - - - -
AUDIO
OUT
L R
G~
,...-,..---1- - - - - - - 1 - - - - - -
t?-
o
When using an optical cable or a BNC cable for the
digi,~al ~udi~
connection, make the settings at GUI menu "Source Select - CD
- "Assign" - "Digital" (!l2irpage 46) .
o
The default analog audio input setting is "RCA". When uSing a
balanced cable for the analog audio connection, make the settings at
GUI menu "Source Select" - "CD" - "Assign" - "Analog" (!l2irpage
471
Connect the cables to be used.
CD player - - - - - ,
.~[.ii.
The default AVP-A 1HDCI balance model XLR input connectors pin
alignment is as shown.
~~~~UND ~
~
• COLD
~
t?-
o
When connecting a record player with an MC cartridge, use a
commercially available MC head amplifier or a step-up transformer.
o
Induction humming (a booming sound) may be produced from the
speakers if the volume is raised with no record player connected.
o
With some record players, noise may be generated when the ground
wire is connected. If so, disconnect the ground wire.
Turntable (MM cartridge)
1I~[.)i.
The AVP-A 1HDCI's SIGNAL GND terminal is meant to reduce noise
when a record player is connected. This is not a safety ground
terminal.
14