Ricoh M052 Service Manual page 394

1001 Bit Switch
009 Bit Switch 9
PDL Auto Detection timeout of jobs
submitted via USB or Parallel Port (IEEE
1284).
bit 0
To be used if PDL auto-detection fails. A failure of PDL auto-detection does
not necessarily mean that the job cannot be printed. This bit switch tells the
device whether to time-out immediately (default) upon failure or to wait 10
seconds.
bit 1 DFU
Job Cancel
If this bit switch, all jobs will be cancelled after a jam occurs.
bit 2
Note: If this bit SW is enabled, printing under the following conditions might
result in problems:
Job submission via USB or Parallel Port
Spool printing (WIM >Configuration > Device Settings > System)
bit 3
DFU
to 7
1003 [Clear Setting]
1003 001 Initialize System
1003 003 Delete Program
SM
0
0: Disable
(Immediately)
Disabled
(Not
cancelled)
Initializes settings in the System menu of the
user mode.
DFU
5-181
Printer Service Mode
1
1: Enable
(10 seconds)
- -
Enabled
(Cancelled)
- -
M052/M053/M054