CUSTOMIZING YOUR KEYSET
SELECT RING TONE
Each keyset user can select any one of eight ring frequencies:
•
While on-hook, press TRANSFER and then dial 111.
•
Dial 1–8 or press the UP and DOWN keys to hear each tone.
•
When you hear the tone that you prefer, press TRANSFER to save it.
CHANGE YOUR PASSCODE
From the factory, your station passcode is 1234. You can change your sta-
tion passcode whenever you desire.
•
While on-hook, press TRANSFER and then dial 101.
•
Dial your old passcode.
•
Dial a new passcode (must be four characters). You can use 0–9.
•
Redial the new passcode to verify. If successful, you will hear two beeps.
Four beeps indicate an incorrect code. Reenter the code again.
•
Press TRANSFER to store the new passcode.
SET ANSWER MODE
You can receive internal calls in one of three modes (see Answering Intercom
Calls under Intercom Calls for descriptions):
•
While on-hook, press TRANSFER and then dial 103.
•
Dial 0 for Ringing, 1 for Auto Answer or 2 for Voice Announce.
•
Press TRANSFER to store your selection.
NOTE: When your keyset is programmed for Auto Answer and you have For-
ward No Answer (FNA) turned on, you must answer screened transfers by
pressing the ANS/RLS key before your FNA timer expires or the call will for-
ward.
AUTOMATIC HOLD
While on an outside call, pressing a line key, route key or a flashing CALL
button will automatically put your call on hold and connect you to the next
call. This feature can be turned on or off at your keyset.
•
With the handset on-hook, press TRANSFER and then dial 110.
•
Dial 01 to turn Automatic Hold on or 00 to turn it off.
•
Press TRANSFER to store your selection.
30