Installation Procedure - GE Match 19" User Manual

g
2.2

Installation Procedure

5 4
1000/1500 VA
models
3
1. Remove the transport screws (A, fig. 1) and store them in the free holes (B, fig.1). Mount the
Match 19" UPS in the 19" rack. The module must be supported by mounting rails, do not mount it
by using the front brackets only. The front brackets allow mounting of handles (not included).
2. Make sure that the air vents in the side panels of the module are not blocked by the mounting
rails or the side panels of the 19" rack.
7. For best results, allow the UPS to recharge the batteries during a period of approx. 2 hours. It is
acceptable to use the UPS without first charging the battery, but the runtime may be reduced.
8. For advanced communication possibilities, the RS232 interface port (3, fig. 1) can be connected
to a computer system and/or optional interface cards (5, fig. 1, 1000/1500VA models only) can be
added. See chapter 4.
OPM_MAE_19X_700_1K5_2GB_V030
2 1
3. Switch off your computer, and unplug it from the
socket-outlet.
4. Disconnect the power cord from the computer (rating
250Vac/10A) and connect this cord to the mains
input socket (2, fig. 1) of the UPS. See fig. 2.
fig. 2
5. Using the output cord(s) provided, connect the
computer(s) to the appliance outlet(s) (4, fig. 1) of
the UPS. Spread the loads over the appliance
outlets as equally as possible. If you use a
distribution box to connect more than one appliance
per outlet, please note that the maximum AC-current
rating of each appliance outlet is 10Amps. See fig. 3.
fig. 3
6. Connect the mains cord of the UPS to a working,
grounded AC wall socket outlet. See fig. 4. The
green LED 'on' (7, fig. 6) will blink: power is available
and the batteries are charging. If the LED does not
blink, press 'I' briefly. Probably LED 'replace battery'
lights up; the LED goes out as soon as the batteries
fig. 4
have been charged.
3 GE DE Match 19" 700-1500: User manual 3.0 (GB)
GE Digital Energy
A
B
fig. 1