Deleting All The Saved Stations; Radio Operations; Improving Poor Fm Reception; Listening To The Radio - Pioneer HTZ-BD50 Operating Instructions Manual

58 Operation

Radio Operations

Be sure that the antenna is connected.
(Refer to the page 24)

Listening to the radio

1. Press INPUT/TUNER until TUNER (FM)
appears in the display window. The last
received station is tuned in.
2. Press and hold TUNE (-/+) for about two
seconds until the frequency indication
starts to change. Scanning stops when the
unit tunes in a station. Or Press TUNE (-/+)
repeatedly.
4
3. Adjust the volume by rotating VOLUME on
the front panel or by pressing VOL (+/- ) on
the remote control.

Presetting the Radio Stations

You can preset 50 stations for FM.
Before tuning, make sure that you have turned
down the volume.
1. Press INPUT/TUNER until the TUNER (FM)
appears in the display window.
2. Select the desired frequency by using TUNE
(-/+).
3. Press ENTER ( ) a preset number will fl ash
in the display window.
4. Press PRESET to select the preset number
you want.
5. Press ENTER ( ). The station is stored.
6. Repeat the steps 2 to 5 to store other
stations.

Deleting all the saved stations

Press and hold CLEAR for two seconds.
"ERASE ALL" will fl ash up. Press CLEAR again.
Then all the saved stations are deleted.

Improving poor FM reception

Press D (blue) (ST/ MONO) colored button on
the remote control. This will change the tuner
from stereo to mono and usually improve the
reception.