Battery; Connect Or Remove The Battery Pack; Insert/Replace Battery - Honeywell MX8 User Manual

Battery

Connect or Remove the Battery Pack

The MX8 will not function unless the battery pack is in place and securely latched.
Be sure to place the unit in Suspend Mode before removing the battery. Failing to properly place the device in Suspend mode
will result in a loss of all unsaved data.
The main battery is located in a compartment on the back of the unit. The battery case serves as the back cover for the battery
well of the MX8.
An MX8 will retain data, while the main battery is removed and replaced with a fully charged main battery, for 5 minutes.
Important: When the internal battery power is Low or Very Low connect the AC adapter to the MX8 before replacing the main
battery.
Note: The battery should not be replaced in a dirty, harsh or hazardous environment. When the battery is
not connected to the MX8, any dust or moisture that enters the battery well or connector may transfer
to the battery/well terminals, potentially causing damage.
Warning : Only use Honeywell MX8A380BATT / 161376-0001 batteries as replacements.

Insert/Replace Battery

To insert the main battery, complete the following steps:
1. Detach the bottom hook of the handstrap (if installed).
2. Tilt the end (without the latch) of the fully charged battery pack into the upper end of the battery compartment, and firmly
press the other end until it is fully inserted into the battery compartment
3. Push down on the battery until the retaining clip clicks into place.
4. Replace the handstrap clip in its holder (if installed).
The MX8 draws power from the battery immediately upon successful connection.
Check battery status by tapping the battery icon at the top right of the Today screen or tap Start | Settings | System | Power
| Battery. Main battery level, internal battery level, status and other details are displayed.
2-2