Overrunning Clutch - Honda GX690 Workshop Manual

STARTING SYSTEM
MAGNETIC SWITCH
Check the continuity between the terminals of the
magnetic switch.
There should be no continuity between the terminals.
If there is continuity, replace the magnetic switch (page
10-4).
BRUSH LENGTH
Measure the brush length.
STANDARD:
SERVICE LIMIT: 6 mm (0.2 in)
If brush length is less than the service limit, replace the
brush (page 10-8).
BRUSH CONTINUITY CHECK
Check for continuity between the positive (+) brushes
(1) and negative (-) brushes (2).
There should be continuity between both the positive
brushes.
There should be continuity between both the negative
brushes.
There should be no continuity between both the positive
and negative brushes.
If the correct continuity is not obtained, replace the yoke
(page 10-4).

OVERRUNNING CLUTCH

Hold the armature (1) as shown and check that the
overrunning clutch (2) turns clockwise and slides
smoothly. If necessary, apply oil or replace the
overrunning clutch (page 10-4).
Check the pinion gear (3) for wear or damage and
replace the over running clutch if necessary (page 10-
4).
If the pinion gear is worn or damaged, the flywheel ring
gear must be inspected.
10-6
10 mm (0.4 in)
(1)
(2)
(2)
(1)
(3)
(2)
(1)