Honda GX690 Workshop Manual page 139

GOVERNOR ARM SHAFT OIL SEAL
(10 x 16 x 5 mm)
Remove the governor arm shaft (page 15-4).
Remove the oil seal (1) from the crankcase (2).
Apply oil to the outer surface of a new oil seal.
Drive the new oil seal until it is fully seated on the end
using the special tools.
TOOLS:
Driver handle 15 x 135L (3)
Pilot 17 mm (4)
Apply grease to the lip of a new oil seal.
07749-0010000
07746-0040400
(2)
CRANKCASE
(1)
(3)
(4)
15-15