Maintenance – CP185: Disassembling and Reassembling the Radio – General
4. Remove the Volume Knob (7) and Channel Knob (8) from their shafts using the Chassis and
Knob Opener. (Refer Figure 6-3).
Chassis and Knob Opener
Note: Both knobs can be turned clockwise and counterclockwise. However, they are designed to
fit very tightly on their shafts.
5. Separate the Chassis (27) from the Front Housing Assembly (1):
a.
Insert the Chassis and Knob Opener in between the thin retaining wall and the chassis
at the bottom of the radio. Do not mar the O-ring sealing area on the housing.
b.
Slowly pry the bottom of the chassis from the housing by pushing the Chassis and Knob
Opener downwards, and prying the handle of the tool over and behind the base of the
radio. This forces the thin inner plastic wall toward the base of the radio thus releasing
the two chassis base tabs. (Refer Figure 6-4).
Marring the front cover O-ring sealing area will prevent the radio from sealing properly. If the
O-ring (24) is damaged, replace it with a new one.
Figure 6-3. Knobs Removal
Figure 6-4. Chassis Removal
Volume Knob
Channel Knob
6-5