Automatic Clock Adjustment - JVC KD-MX2800R Instructions Manual

Automatic clock adjustment

When shipped from the factory, the clock built in this unit is set to be readjusted automatically
using the CT (Clock Time) data in the RDS signal.
If you do not want to use automatic clock adjustment, follow the procedure below.
• See also "Changing the general settings (PSM)" on page 31.
1. Press and hold SEL (select) for more than 2 seconds so that "PSM" appears on the lower
part of the display.
2. Select "AUTO ADJUST" with ¢
3. Select "ADJUST OFF" by turning the control dial counterclockwise.
Now automatic clock adjustment is canceled.
To reactivate clock adjustment, repeat the same procedure and select "ADJUST ON" in
step 3 by turning the control dial clockwise.
Note:
It takes about 2 minutes to adjust the time using the CT data. So, you must tune to the station for more
than 2 minutes continuously; otherwise, the clock time will not be adjusted.
or 4
.
17