Initial System Start-Up; Adjusting Volume; Radio; Listening To Radio - Alpine CDE-143EBT Owner's Manual

Initial System Start-Up

Be sure to press the RESET button when using the unit for the first time,
after changing the car battery, etc.
1
Turn off the unit power.
2
Remove the detachable front panel.
3
Press RESET with a ballpoint pen or similar pointed object.
RESET button

Adjusting Volume

Turn the Rotary encoder until the desired sound is
obtained.
Controllable with Remote Control
This unit can be controlled with the supplied Alpine remote control.
For details, consult your Alpine dealer. Point the supplied remote
control transmitter at the remote-control sensor.
Remote control sensor
* The illustration is for CDE-143EBT/CDE-143EBTTH.
Connectable to Remote Control Interface Box
With an optional Alpine Steering Wheel Remote Control Interface
Box (not included), this unit is controllable from the vehicles
steering wheel controls. For details, contact your Alpine dealer.

Radio

SOURCE/ 
Rotary encoder

/ENTER
TUNE/A.ME
 
BAND
* The illustration is for CDE-143EBT/CDE-143EBTTH.

Listening to Radio

1
Press SOURCE to select TUNER mode.
2
Press BAND repeatedly until the desired radio band is
displayed.
F1 (FM1)  F2 (FM2)  AM  F1 (FM1)
3
Press TUNEA.ME to select the tuning mode.
SEEK DX (Distance mode)  SEEK LOCAL (Local mode) 
MANUAL (Manual mode)  SEEK DX
Note
• The initial mode is Distance mode.
Distance mode:
Both strong and weak stations will be automatically tuned in
(Automatic Seek Tuning).
Local mode:
Only strong stations will be automatically tuned in (Automatic
Seek Tuning).
Manual mode:
The frequency is manually tuned in steps (Manual tuning).
4
Press  or  to tune in the desired station.
Holding down  or  will change the frequency
continuously.

Presetting Stations Manually

1
Select the radio band and tune in a desired radio station
you wish to store in the preset memory.
2
Press and hold, for at least 2 seconds, any one of the
preset buttons (1 through 6) into which you wish to store
the station.
The selected station is stored.
The display shows the band, preset number and station
frequency memorized.
Notes
• A total of 18 stations can be stored in the preset memory (6 stations for
each band; FM1, FM2 and AM).
• If you store a station in a preset memory which already has a station,
the current station will be cleared and replaced with the new station.
Preset buttons
(1 through 6)
9
-EN