Graco GM3000 Instructions-Parts List Manual page 29

The face of the housing.
1
2
1.41 ".010 inch (35.8 ".25 mm).
3
Torque the screws to
120 in–lb (14 N.m).
1
1
B
Fig. 22
Reassembly
The sprayer will be out of balance when only the
engine and clutch housing are installed. Support the
rear of the cart to prevent the sprayer from falling
over.
5. Place the engine (48) assembly on the cart. Align
the mounting holes. Carefully guide the engine
wire and wiring harness (E) from the field, through
2
the appropriate grommets (50) in the mounting
plate (A). Install the flange screws (77) and lock-
nuts (78). Install the screw (61). Tighten all three
screws. Connect the engine wire to the red wire
(B), and connect the black and white wires as
shown in the Detail drawing in Fig. 16.
58
3
05078
CAUTION
308620 29