Pressure Transducer - Graco GM3000 Instructions-Parts List Manual

WARNING
INJECTION HAZARD
To reduce the risk of serious injury,
whenever you are instructed to relieve
pressure, follow the Pressure Relief
Procedure on page 12.
NOTE: See Fig. 9 for this procedure.
1. Remove the displacement pump. See page 31.
2. Use a pull–twist motion to remove the transducer
(22) from the pump manifold.
3. Clean paint residue from the hole in the manifold;
do not scratch the surface of the hole.
4. Lightly apply oil to the o-ring of the new transducer.
5. Install the transducer in the pump manifold, while
guiding the o-ring and backup ring into place.
6. Align the holes in the transducer as shown by the
arrows in Fig. 9.
7. Install the displacement pump. See page 32.
20 308620

Pressure Transducer

22
Fig. 9
05835A