Trouble Shooting - Clarity CCE203DAB Instruction Manual

Trouble Shooting

The following chart will help in solving most problems that may occur. If you still have questions
after going through the checklist, please consult your local customer service representative.
Before going through this check list, refer the wiring and operating procedures.
Symptom
No power
Disc can not be loaded
or ejected.
No sound
Sound skips
The operation keys
do not work
No radio reception.
In automatic search mode
the radio does not stop at
a transmitting station.
Cause
The car ignition switch have
not turn on.
The fuse has been blown.
Presence of CD disc inside
the player.
Inserting the disc in reverse
direction.
The surface of CD is extremely
dirty or has been scraped.
Temperature inside the car
is too high.
Condensation
Volume is in minimum
The wiring is not properly
.
connected
The installation angle is
0
more than 30 .
The surface of CD is extremely
dirty or has been scraped.
1. The built-in microcomputer
is not operating properly due to noise.
2. The front panel has not
properly installed.
The antenna cable is not connected.
The transmission signals are
too weak.
If the power supply is connected to
the car accessory circuits, but the
engine is not moving, switch the
ignition key to "ACC".
Replace a new one.
Remove the disc from the player,
and insert a new one.
Insert the CD with the label facing
upward.
Clean the disc or try to replace
a new one.
Cool off or until the ambient
temperature return to normal.
Leave the player off for an hour or so,
and then try again.
.
Adjust volume to a desired level
Check wiring connection
Adjust the installation angle
less than 30
Clean the disc or try to replace
a new one.
1. Press the
to restore the program.
2. Fixed the front panel into
its place.
Insert the antenna cable firmly into
the antenna socket of this CD player.
Select a radio station manually.
Solution
.
.
0
RESET button
.