Table of Contents
Advertisement
Advertisement
Table of Contents
Summary of Contents for Clarity CCE203DAB
-
Page 2: Table Of Contents
Page CONTENTS Contents Safety instructions Installation Using the detachable front panel Wiring Diagram Operations Location and Function of Keys General Operations Radio Operations RDS (Radio Data System) Operations DAB Radio Operations CD/MP3 Disc Operations Mixed-CD Operations AUX in Operations USB Device Operations SD/MMC Card Operations Disc Notes Trouble Shooting... -
Page 3: Safety Instructions
Safety Instructions CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE ANY COVERS. NO USER-SERVICEABLE PARTS INSIDE, REFER ANY SERVICING TO QUALIFIED SERVICE PERSONNEL. IMPORTANT SAFETY INSTRUCTIONS • Read and keep these instructions available for future reference. • The unit must only be connected to a 12 Volt D.C. -
Page 4: Installation
Take Out Screw Before Installation Installation Before install the unit, please remove the two screws. Notes: - Choose the mounting location where the unit will not interfere with the normal driving function of the driver. - Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and the 1. - Page 5 10. Reconnect the cable to the vehicle 6. Mount the sleeve by inserting the sleeve into the opening of the dashboard and bend battery's negative (-) terminal. Then open the tabs located around the sleeve replace the outer trim ring and install the with a screwdriver.
-
Page 6: Using The Detachable Front Panel
Using The Detachable Front Panel 2. DIN REAR-MOUNT (Method B) REMOVING AND PROTECTING If your vehicle is a Nissan, Toyota, follow DETACHABLE FRONT PANEL this mounting instruction. Use the screw The front panel of the unit may be removed holes marked T (Toyota), N (Nissan) as a theft deterrent. -
Page 7: Wiring Diagram
Wiring Diagram RCA connector to front left output (White) RCA connector to rear left output (White) DAB Antenna Socket FUSE Antenna Socket ISO CONNECTOR RCA connector to rear right output (Red) RCA connector to front right output (Red) TO TEL. MUTE CABLE ORANGE YELLOW TO MEMORY B+... -
Page 8: Operations
Operations Location and function of keys Front panel : CCE203DAB DISP PUSH The car radio after removing the front panel: Descriptions of Function Controls Power on/off( ) Button (16) 9 / UP ( ) Button LCD display Tune up, Seek up, next track, fast forward... -
Page 9: General Operations
system setup menu mode, then press the General Operations VOLUME / SELECT button to select the menu item in sequence as follows: Reset the unit The RESET button is to be activated for the “TA SEEK or TA ALARM” “PI SOUND or PI following reasons: MUTE”... - Page 10 FREQUENCY -> "DAB-FM Y”, “DAB-FM N” In CD/USB/SD/MMC mode: CT-> PTY(Type The CCE203DAB can switch between DAB of program) -> FREQUENCY -> PS -> Track and FM automatically, it allows you to set number /Running time or other information...
-
Page 11: Radio Operations
Note: Radio Operations If the unit does not receive CT or PTY information, the display shows “NO Switching to radio mode CLOCK” or “PTY NONE”. Press the MODE button to select the radio mode. - When receiving a non RDS station: In radio mode:NO CLOCK->PTY NONE->... -
Page 12: Rds (Radio Data System) Operations
preset station. If the field strength level is RDS (Radio Data System) Operations more than the threshold level, the radio will hold at this preset station for 5 seconds with The RDS data are the PI, PS, TP, PTY, TA sound output, then go to next station until and AF data. -
Page 13: Dab Radio Operations
HINT: DAB Radio Operations When you choose MUSIC PTY GROUP , the preset number buttons 1-6 correspond to the following programs: DAB is the abbreviated form of the “Digital Preset Music PTY Group Audio Broadcasting”. The biggest number difference of the DAB and FM/ MW POP M, ROCK M traditional broadcasting , besides the DAB EASY M, LIGHT M... -
Page 14: Cd/Mp3 Disc Operations
Automatically Switching between DAB beginning. The track number shows on the and FM LCD display. switch CCE203DAB will automatically switch Playing forward and backward - When the DAB signal of the current During playback, press and hold the program is lost or becomes too weak, the button to fast forward or fast reverse. -
Page 15: 4 Mixed-Cd Operations
Go to the previous / next directory Then press the VOLUME/SELECT button During MP3 playback, press the BAND (ENTER) button to confirm and play button to select the previous or next the selected file. directory. If the MP3 disc does not contain c You can also input the file number any directories, this function will not be directly by pressing the corresponding... -
Page 16: 5 Usb Device Operations
USB Operations SD/MMC Memory Card Operations CD/MP3 car radio is equipped with a CD/MP3 car radio is equipped with USB port on the front panel of the unit, you SD/MMC card slot, you can play the MP3 can connect a USB stick through the USB songs in the SD/MMC card a by the CD/MP3 port. -
Page 17: Disc Notes
- Do not warp discs. Disc Notes - A disc should always be kept in its case when not in use to prevent from damage. A. Notes on discs: - Do not place discs in the following places: 1. Attempting to use non-standard shape 1. -
Page 18: Trouble Shooting
Trouble Shooting The following chart will help in solving most problems that may occur. If you still have questions after going through the checklist, please consult your local customer service representative. Before going through this check list, refer the wiring and operating procedures. Symptom Cause Solution... -
Page 19: Specifications
Specifications 1. GENERAL Power Supply Requirements DC 12 Volts, Negative Ground Chassis Dimensions 178(W)x160(D)x 50(H) mm Tone Controls - Bass (at 100 Hz) ±10 dB - Treble (at 10KHz) ±10 dB Maximum power output 4 x 40 watts Power consumption 15 Ampere (max.) 2.