Sony MZ-R500PC Service Manual page 29

[VOL+]
71. Adjust with the key (adjusted value up) or
key (adjusted value down) so that the adjusted value becomes
03.
This set LCD display
0 2 3
03: Adjusted value
72. Press the key.
X
(0D76 is blinking)
[VOL+]
73. Press the key to change the blinking portion to 0D78.
This set LCD display
0 2 3
00: Adjusted value
74. Press the x key.
(00 is blinking)
[VOL+]
75. Adjust with the key (adjusted value up) or
key (adjusted value down) so that the adjusted value becomes
01.
This set LCD display
0 2 3
01: Adjusted value
76. Press the key.
X
(0D78 is blinking)
[VOL+]
77. Press the key once to change the blinking portion to
0D79.
This set LCD display
0 2 3
00: Adjusted value
78. Press the x key.
(00 is blinking)
[VOL+]
79. Adjust with the key (adjusted value up) or
key (adjusted value down) so that the adjusted value becomes
E0.
This set LCD display
0 2 3
E0: Adjusted value
80. Press the key.
X
(0D79 is blinking)
[T.MARK]
81. Press the key for several seconds (about 3 seconds)
to exit the patch data write mode (to return to the manual mode
display in the test mode).
This set LCD display
0 23
[VOL--]
0D7603
0D7800
[VOL--]
0D7801
0D7900
[VOL--]
0D79E0
Patch
[ENTER]
82. Press the key and set the address & adjusted value
display (see page 14).
This set LCD display
0 2 3
01: Adjusted value
83. Press the key to write the modified data. (The adjusted value
X
changes to CC)
84. The modified data writing is over, if the adjusted value changes
to DD.
This set LCD display
0 2 3
DD: Adjusted value
85. Turn the power off.
MZ-R500/R500PC
S01
SDD
29