Installing Expansion Boards And Other Major Hardware Options; Preparing The Mounting Brackets And Slide Rail Assemblies - Compaq Proliant ML370 User Manual

Installing Expansion Boards and Other
Major Hardware Options
Before mounting the server in the rack, install any PCI and expansion boards.
Chapter 4, "Installing Hardware Options," provides instructions for installing
these and other major hardware options.
The following major hardware options are available for the ProLiant ML370
server and may be obtained from your local Compaq authorized reseller or
Compaq authorized service provider:
Hot-plug hard drives


Memory


Additional processor and Processor Power Module (PPM)


Integrated Smart Array Controller upgrade or other SCSI array


controllers
Tape drives


Compaq Integrated Management Display (IMD)


Remote Insight Board


Compaq hot-plug redundant power supply


Optional uninterruptible power supply (UPS)


This guide covers only the installation of hard drives, tape drive, memory,
integrated array controller, and a second processor unit.
Preparing the Mounting Brackets and
Slide Rail Assemblies
Each pair of mounting brackets, with attached slide rail assemblies, supports
one rack server.
NOTE: Alignment tabs on the rack mounting brackets identify front flanges.
Each slide rail assembly consists of an outer bracket rail and an inner
component rail like the ones shown below. These pieces can be separated to
attach to the frame. Attach the bracket rails to the rack mounting brackets and
the component rails to the sides of the server chassis.
Installing the Rack Model ProLiant ML370 3-11