Fireplace Log Set Placement - Cal Flame FRP-1000 Owner's Manual

Fireplace Log Set Placement

The log set, log grate and crushed lava rock are shipped
together on applicable models. Remove the log set and
un-pack all components. The logs are fragile -- use care
when handling.
Do not install the log set in an unvented appliance.
Once the fireplace is in position, level and safely hooked
up to the proper fuel supply, install the log grate over the
plate burner.
Place the lava rock around the flat burner plate. DO NOT
place the lava rock on the burner plate as it will affect the
flow of the flame.
Log Placement for FRP-4300
2008 Fireplace and Firepit Owner's Manual
LTR20081006, Rev. A
Installation and Assembly
Place the ceramic fire logs on the grate. Start by laying
one log in the centre of the grate length wise.
Lay the other logs (quantity may vary by unit type) over
the first log as shown below.
NOTE: Be sure unit is cool before touching any of
the components .
For the FRP-4300 place two logs length wise in the
grate and position remaining logs over them in an
angled position as shown in Placement Picture for
FRP-4300. Ensure the logs are place securely to avoid
any movement.
Log placement for
FRP-1000, 1500, 2000, 3000, 3100
Page 7