Lighting Instructions For Automatic Starter - Cal Flame FRP-1000 Owner's Manual

Lighting Instructions for Automatic Starter

For THIS kind of starter:
1. Remove protective storage cover and locate the
manual gas control valve and igniter button on the
fireplace.
2. Make sure fuel supply is properly connected and
turned on at the source / tank.
Depress igniter button until you hear it sparking. You
3.
will hear a small popping noise. Keep igniter button
pushed in while turning the fuel flow valve to the full
flow position at the fireplace. The fireplace should
light within 5 seconds. If you do not hear the igniter
sparking you may need to replace / install the battery.
Replace / install with a standard AAA battery, directly
behind the rubber push button knob, (unscrew knob
to access battery). Note some models ship with the
batteries removed or may not be included with your
model.
If a flame does not start within 10 seconds, shut off
4.
all gas supply and wait FIVE, (5), minutes to allow all
gas fumes to clear. Re-try or go to trouble-shooting
and start from Step-1 again.
2008 Fireplace and Firepit Owner's Manual
LTR20081006, Rev. A
Applies to the following fireplaces:
FRP-1000
FRP-1100
FRP-1500
FRP-2000
FRP-3000
Applies to all fire pits:
To Turn Off Gas
Turn the ON/OFF valve to the off position at the unit for
Natural Gas unit. For LP unit, turn the ON/OFF valve to
the OFF position at the unit and then turn the valve on
the LP tank to the OFF position clockwise.
NOTE
The propane regulator in this appliance is equipped
with a low flow protection device. Unless the propane
cylinder valve is opened before the valve, the gas flow
will be reduced resulting in a very small flame.
To reset this device, shut off the valve, then the propane
cylinder valve.
Follow the lighting procedure ensuring the propane
cylinder valve is opened before the unit is.
Operation
FRP-3100
FRP-3200
FRP-4300
FRP-4400
Page 11