Fire Pit Burner Installation - Cal Flame FRP-1000 Owner's Manual

Installation and Assembly

Fire Pit Burner Installation

The log set, log grate and crushed lava rock are shipped together on applicable models.
Remove the log set and un-pack all components. The logs are fragile -- use care when handling.
Place the fire pit back down on its pedestal. Attach the
gas flex hose to the burner.
Note: If you want to convert the orifice from LP to NG,
this is location of the orifice. See next page for gas
converstion instructions.
Place the rocks around the burner.
Page 8
Turn the fire pit on its side. Connect the
piezoelectric starter and attach the flex hose
for the gas supply.
Set the burner in the center of the pit and place the ring
around it.
Arrange the log set on top.
2008 Fireplace and Firepit Owner's Manual
Applies to all fire pits.
LTR20081006, Rev. A