Installation; Figure 3-1 Installation, Front View; Figure 3-2 Installation, Back View - Honeywell OWA 100 User Manual

3.2

Installation

1. Loosen the four M4 screws to remove the cover, (See Figure 3-1)
If a new battery needs to be installed follow the directions for Replacing the Battery in Section
5.2.
If a battery is installed remove the shipping tag between the battery and battery holder and replace
the cover. Torque M4 screws to 1.0 N.m / 9.0 lbf-inch
2. Remove termination cover to which the adapter is to be connected.
3. Remove plastic protective cover on adapter hub
4. Insert wires through conduit entry of the unit to which it is to be mounted then start to thread the
adapter hub into the conduit entry. Use the hex on the adapter hub (smaller hex - See Figure 3-2))
to securely tighten the adapter hub to the unit (See Note). To reorient the antenna of the adapter
loosen the jam nut (Turn larger hex nut CC when looking at the front of the OWA 100 Adapter)
and rotate the unit to the desired antenna location then retighten the jam nut to 9 N.m /7lb-foot.
Note: The rotation of the unit is limited to 350 degrees.
5. Install the four wires per the OWA 100 Adapter Interconnection Diagram per Figure 3-5 to Figure
3-12.
6. Replace the termination cover.
Note: It is the User/Installer's responsibility to install the 100 Adapter in accordance with the national and
local code requirements.

Figure 3-1 Installation, Front view

Rev. 2
July 2011
OWA 100 Adapter User Manual

Figure 3-2 Installation, Back view

3. Configuration
3.2. Installation
11