Keep Filling Water - Haier HLT364XXQ Service Manual

No draining
After insert the plug, turn the
sequencer knob to the drain location
Check if the drain pump acts.
Check if the drain motor is normal
Check the inset is normal
and measure the voltage of two ends of
the drain motor
Check if the wire unit is normal
Replace the sequencer

Keep filling water

Open the water faucet without switching on the power.
If the water can fill into the water inlet valve.
check if the gas guide system such
as gas cell leaks gas
Replace the water level sensor.
MAINTENANCE SERVICE AND TROUBLE SHOOTING
No
No
No Exist
Yes
Yes
No
Yes
No
Check the inset is normal
and measure the voltage of two ends of
the drain pump
No Exist
Check if the wire unit is normal?
Yes
Replace the sequencer
Replace the water inlet valve.
It leaks gas. Please check and repair the gas guide system.
Please smear 801 glue in installation of the connecting pipe.
Please smear 801 glue in installation of the gas cell cover.
Exist
Replace the drain pump
No
Repair or replace the wire unit