Adjusting The Oven Temperature; Restoring To Factory Default Settings; Operating The Oven Light - Frigidaire Gas Range Use & Care Manual

SETTING OVEN CONTROLS

Adjusting the oven temperature

Your appliance has been factory calibrated and tested to
ensure an accurate baking temperature. For the first few
uses, follow your recipe times and temperature
recommendations carefully. If you think the oven is cooking
too hot or too cool for your recipe times, you can adjust the
control so the oven cooks hotter or cooler than the
temperature displayed.
The oven temperature my be increased +35°F (+19°C) or
decreased -35°F (-19°C) from the factory settings.
Example: increase the oven temperature by 30°F:
Step
1. Press and hold bake
for 6 seconds.
2. Enter 30.
3. To accept, press start.
Example: decrease the oven temperature by 30°F:
Step
1. Press and hold bake
for 6 seconds.
2. Enter 30.
3. Press self clean.
4. To accept, press start.
NOTES
• Oven temperature adjustments made will not affect
the broil or self-cleaning feature temperatures.
• If the temperature shows an adjustment of -30°F, and
a +30°F adjustment is needed, you can toggle between
the (-) or (+) in the display by pressing self clean.
• DO NOT USE oven thermometers such as those found
in grocery stores to check the temperature settings
inside your oven. These oven thermometers may vary
as much as 20 to 40 degrees from actual
temperatures.
22

Restoring to factory default settings

When new, your appliance was set with a few
predetermined oven control settings. Over time, the user
may make changes to these default settings.
The following functions or features have user program
options or adjustments that may have been changed from
the original default settings:
• 12 or 24 hour clock display mode.
• 6-Hour Engergy Savings or continuous bake mode.
• Silent or audible keypad operation.
• Oven temperature display mode (F° or C°).
• Any oven temperature offset adjustment made.
Press
• Probe options (some models).
• Any stored favorite recipes (some models).
Before restoring the settings, please be aware that all
changes made to the oven control settings will be
erased once the start keypad is pressed. This includes
any temperature offset made for the oven when baking.
Press
To restore oven control to default settings:
Step
1. Press and hold 7 keypad until
acceptance tone sounds
(about 6 seconds).
2. To accept, press start.

Operating the oven light

The interior oven light will automatically turn ON when the
oven door is opened. Press
light ON and OFF whenever the oven door is closed. The
interior oven light is located at the upper left rear wall of
the oven interior and is covered with a glass shield held by
a wire holder. The glass shield must be in place whenever
the oven is in use.
To change the interior oven light, see "Changing the oven
light" in the Care & Cleaning section.
IMPORTANT
Press
to turn the interior oven