Air Filter For Drive Belt/ Spark Plug - KYMCO Mongoose/KXR 250 Service Manual

3
. INSPECTION/ADJUSTMENT
AIR FILTER FOR DRIVE BELT
To clean the air filter:
Remove the two screws attaching front
fender and remove air filter housing.
Remove the two screws and remove air
filter housing cover.
Remove the air filter from the housing.
Tap the air filter lightly to remove most of
the dust and dirt.
Blow out the remaining dirt with
compressed air.
If the element is damaged, replace it.
Reassemble by reversing the disassembly
sequence.
SPARK PLUG
Remove ignition coil cap and spark plug.
Check the spark plug for wear and fouling
deposits.
Clean any fouling deposits with a spark
plug cleaner or a wire brush.
Specified Spark Plug: DPR7EA-9
Measure the spark plug gap.
Spark Plug Gap: 0.6～0.7mm
When installing, first screw in the spark
plug by hand and then tighten it with a
spark plug wrench.
Screws
Air Filter
Air Filter Housing
Ignition Coil Cap
Gap, Wear, and Fouling Deposits
Washer Deformation
Mongoose/KXR 250
Air Filter Cover
Screw
Spark Plug
Cracks, Damage
3-6