York R51 Owner's Manual page 4

TEMP Button : Push the TEMP button to decrease the indoor
1
temperature setting or to adjust the TIMER in a counter-clockwise
direction.
MODE Select Button: Each time you push the button, a mode is
2
selected in a sequence that goes from AUTO
HEAT and FAN as the following figure indicates:
AUTO(COOL)
NOTE: HEAT only for Heat Pump
SWING Button: Push this switch button to change the louver
3
angle .
RESET Button: When the RESET button is pushed, all of the current
4
settings are cancelled and the control will return to the initial settings.
ECONOMIC RUNNING Button:
5
Energy-Saving operation mode.
LOCK Button: Push this button to lock in all the current settings. To
6
release settings, push again.
7
CANCEL Button: Push this button to cancel the TIMER settings.
TIMER Button: This button is used to preset the time ON (start
8
to operate) and the time OFF (turn off the operation).
ON/OFF Button: Push this button to start the unit operation. Push
9
the button again to stop the unit operation.
FAN SPEED Button: This button is used for setting Fan Speed in
10
the sequence that goes from AUTO LOW
back to Auto.
TEMP Button : Push the button to increase the indoor temperature
11
setting or to adjust the TIMER in a clockwise direction.
VENT Button : Push this button to set the ventilating mode. The
12
ventilating mode will operate in the following sequence :
Continuous
Ventilation Function is available for the Fresh Star Series.
COOL DRY
Push this button to go into the
MED to HIGH, then
、 、
Auto
2
、 COOL DRY 、 、
HEAT FAN
Off