Fujitsu PRIMEQUEST 2000 Series Installation Manual page 2

Preface
This manual describes the functions and this manual describes how to set up this product, including the steps for
installation of the PRIMEQUEST 2000 series server, initialization, and software installation. The manual is intended for
system administrators.
For details on the regulatory compliance statements and safety precautions, see the PRIMEQUEST 2000 Series Safety
and Regulatory Information (CA92344-0523).
Organization of this manual
This manual is organized as follows.
CHAPTER 1 Installation Overview
Chapter 1 describes the workflow up to actual operation of the PRIMEQUEST 2000 series server
CHAPTER 2 Preparing for Main Unit Installation
Chapter 2 describes the preparation before main unit installation. This preparation includes work up to power
cable connection.
CHAPTER 3 Work before Operating System Installation
Chapter 3 describes the work that must be done before you install an operating system on the PRIMEQUEST 2000 series
server. The chapter also describes settings for actual operation and various setup works.
CHAPTER 4 Installation of Operating System and bundled software
Chapter 4 describes how to install the operating system and bundled software.
Chapter 5 describes how to make various necessary settings after operating system.
CHAPTER 6Work after installation
Chapter 6 describes the work performed after PRIMEQUEST 2000 series installation. This work includes configuring NTP
and security.
CHAPTER 7Power ON and OFF of the partition
Chapter 7 describes partition power control.
Appendix A List of setting items
Appendix A provides links to Appendix A List of Settings in the PRIMEQUEST 2000 Series Tool Reference (CA92344-
0539)
Appendix B About software
Appendix B provides a link to 3.3 Bundled Software in the PRIMEQUEST 2000 Series General Description (CA92344-
0534).
Appendix C Configuring the SAN boot environment
Appendix C is a link to the PRIMEQUEST 2000 Series SAN Boot Environment Configuration Manual (C122-E206EN).
Appendix D Notes on VMware installation
Appendix D describes the procedure for installing an internal hard disk in a RAID environment in VMware vSphere and
provides notes on installation
Appendix E Setting up the NTP Server (Windows)
Appendix E describes how to specify and set of an NTP server for a specific Windows operating system
Preface
i
CA92344-0536-01