Carrier A07049 Installation Instructions Manual page 9

AC/HP Control should NOT be mounted:
Close to a window, on an outside wall, or next to a door leading to the
S
outside.
Exposed to direct light or heat from a lamp, sun, fireplace, or other
S
temperature- -radiating objects which could cause a false reading.
Close to or in direct airflow from supply registers and return- -air regis-
S
ters.
In areas with poor air circulation, such as behind a door or in an al-
S
cove.
Installer should determine whether control will be installed as single- -piece or
two- -piece. In single- -piece configuration, as many as 14 wires may need to run
to wall mounting location for connection to the control. In two- -piece
configuration, the Display Module and Equipment Control Module are
connected by two wires.
Install AC/HP Control
WARNING
!
ELECTRICAL OPERATION HAZARD
Failure to follow this warning could result in personal injury or
death.
Before installing AC/HP Control, turn off all power to
equipment. There may be more than 1 power disconnect.
9