Mercedes-Benz C-Class Operator's Manual page 123

C-class
Hide thumbs Also See for C-Class:
Table of Contents

Advertisement

Press the respective bulb :, ; or = back
X
and turn it counter-clockwise to remove it
from the bulb holder.
Insert the new bulb into the bulb holder and
X
turn it clockwise.
Reinsert the connector for LED light
X
functions in the bulb holder.
Insert the bulb holder again and lock it in
X
place.
Insert the tail lamp connector.
X
Close the side trim panel (
X
Windshield wipers
Switching the windshield wipers on/
off
G
WARNING
The windshield will not longer be wiped
properly if the wiper blades are worn. This
could prevent you from observing the traffic
conditions, thereby causing an accident.
Replace the wiper blades twice a year, ideally
in spring and fall.
! Do not operate the windshield wipers
when the windshield is dry, as this could
damage the wiper blades. Moreover, dust
that has collected on the windshield can
scratch the glass if wiping takes place when
the windshield is dry.
! If the windshield wipers leave smears on
the windshield after the vehicle has been
washed in an automatic car wash, wax or
other residues may be the reason for this.
Clean the windshield using washer fluid
after washing the vehicle in an automatic
car wash.
5
Rain sensor set to low sensitivity.
6
Rain sensor set to high sensitivity.
Combination switch
page 119).
Y
$ Windshield wipers off
1
2
Ä Intermittent wipe, low
3
Å Intermittent wipe, high
° Continuous wipe, slow
4
¯ Continuous wipe, fast
5
í Single wipe/ î To wipe the
B
windshield using washer fluid
Switch on the ignition.
X
Turn the combination switch to the
X
corresponding position.
! Intermittent wiping with rain sensor: due
to optical influences and the windshield
becoming dirty in dry weather conditions,
the windshield wipers may be activated
inadvertently. This could then damage the
windshield wiper blades or scratch the
windshield.
For this reason, you should always switch
off the windshield wipers in dry weather.
In the Ä or Å position, the appropriate
wiping frequency is set automatically
according to the intensity of the rain. In
the Å position, the rain sensor is more
sensitive than in the Ä position, causing
the windshield wipers to wipe more
frequently.
I n f o r ma t i o n P r o v i d e d b y :
Windshield wipers
5
6
Z
121

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents