Hoover vogue 5015PH Instruction Manual page 18

Maintenance
Changing the Motorised Powerhead Drive Belt (continued)
End Cap
18.
(continued)
3. First lift up the end of the rotating brush with no belt
and remove it. Then lift the end cap where the belt
loops around.
4. Slide the old belt off the drive shaft and then the end
cap. If the belt is broken, remove all the broken pieces.
5. Place the new belt over the drive shaft first and then the
end cap. Make sure the lettering on the belt is on the
outside. Insert the end cap into the groove.
6. Holding the rotating brush, insert it into the end cap first
and then into the groove on the other side.
7. Replace the bottom plate.