JVC GET0117-001A Instructions Manual page 24

PRECAUTIONS on power supply and
speaker connections:
•
DO NOT connect the speaker leads of the power
cord to the car battery; otherwise, the unit will
be seriously damaged.
•
Connect the black lead (ground), yellow lead (to
car battery, constant 12V), and red lead (to an
accessory terminal) correctly.
•
BEFORE connecting the speaker leads of the power
cord to the speakers, check the speaker wiring in
your car.
– If the speaker wiring in your car is as
illustrated in Fig. 1 and Fig. 2 below, DO NOT
connect the unit using that original speaker wiring.
If you do, the unit will be seriously damaged.
Redo the speaker wiring so that you can connect
the unit to the speakers as illustrated in Fig. 3.
– If the speaker wiring in your car is as
illustrated in Fig. 3, you can connect the unit
using the original speaker wiring in your car.
– If you are not sure of the speaker wiring of your
car, consult your car dealer.
+ +
L
- -
+ +
R
-
-
Fig. 1
Connecting the leads /
Twist the core wires when connecting.
!
B Connections Adding Other Equipment /
!"
Amplifier / /
You can connect an amplifier to upgrade your car
stereo system.
•
Connect the remote lead (blue with white stripe) to
the remote lead of the other equipment so that it
can be controlled through this unit.
•
Connect this unit's line-out terminals to the
amplifier's line-in terminals.
•
Disconnect the speakers from this unit, connect
them to the amplifier. Leave the speaker leads
of this unit unused. (Cover the terminals of the
these unused leads with insulating tape, as
illustrated above.)
Rear speakers
L
R
Signal cord (not supplied with this unit)
! !"#$%
!"#$%&'()*
!"#$%&'&()*+,-./01
•
!"
!"#$%&"'
•
!"#$%&12V
!"#$%&'()
!"#$%&%' !"()*+,-.
•
!"#$%&
!"#$%&'()* 1
–
!"#$%&'()*+, !-./
!"#$ %&'()*+,-./0
!"#$%&'()*+
3
!"#$%&'()*3
–
!"#$%&'()*+,
!"#$ %&'()*+,-./
–
!"#$%&
+ +
L
-
-
+
+
R
-
-
Fig. 2
!"#
/
Solder the core wires to
connect them securely.
!"#$%&'()
!"#$%&'(
/
!"#$% &' ()*+,-./
! !"# $%&
•
!"#$%&'(&)*+,-.
!"#$%&'()"*$%+,-
•
!"#$%&'()*+,!- #$
•
!"#$%&'(
!"#$% &'()*+,-
Remote lead
!"
JVC amplifier
INPUT
JVC
L
JVC
JVC
R
* 2
LINE OUT
L
L
KD-S595
REAR
R
R
Front speakers
!"
•
! !"#
•
!"#$
•
–
2
1 2
!
–
3
–
CAUTION /
• To prevent short-circuit, cover the terminals of the UNUSED leads with insulating
tape.
!"#$%&'()*+,-.'!/0123
•
•
!"#$ •
•
(Line-out)
(Line-in)
•
!"#$%&
Y-connector (not supplied with this unit)
!"
Y
Y
Blue with white stripe
!" #$
*2 Firmly attach the ground wire to the metallic body or to the chassis of the car—to the place not coated with paint
(if coated with paint, remove the paint before attaching the wire). Failure to do so may cause damage to this unit.
!"#$%&'($)*+,-./-.0123456789
*2
!"#$%&'()*+,
*2
4
12
3
+ +
L
-
-
+
+
R
-
-
Fig. 3
/
/
!"#$%
Y
To automatic antenna (if any)
!"#$%
!"#$%&'()*+,&-$%
•
•
•
(Insulating tape)
•
•
•
•
!"#
*2