Mb Intelligent Bios Iii) Menu - ECS A75F2-M2 User Manual

M.I.B III (MB Intelligent BIOS III) Menu
This page enables you to set the clock speed and system bus for your system. The
clock speed and system bus are determined by the kind of processor you have
installed in your system.
Main Advanced
Core Clock multiplier
Memory Clock
Memory Timing Configuration
Memory Clock DCT0 is:
Command Rate
CAS# Latency(tCL)
RAS# to CAS# Delay (tRCD)
Row Precharge Time (tRP)
RAS# Active Time (tRAS)
Memory Clock DCT1 is:
Command Rate
CAS# Latency(tCL)
RAS# to CAS# Delay (tRCD)
Row Precharge Time (tRP)
RAS# Active Time (tRAS)
SB Spread Spectrum
CPU Over-clocking Func.
IGD Over-clocking Func.
Core Clock Multiplier (Auto)
Use this item to set the core clock multiplier.
Memory Clock (Auto)
This item is used to set the memory clock.
Memory Timing Configuration (Auto)
This item shows the information of Memory Timing Configuration.
Memory Clock DCT0/1 is (None/DDR-1333/667 Mhz)
These items show current memory clock of DCT0/1.
Command Rate (N/A/1 T)
This item is used to set command rate.
CAS# Latency (tCL) (N/A/9 CLK)
This item determines the operation of DDR SDRAM memory CAS (column address
strobe). It is recommended that you leave this item at the default value. The 2T
setting requires faster memory that specifically supports this mode.
RAS# to CAS# Delay (tRCD) (N/A/9 CLK)
This item specifies RAS# to CAS# delay to Rd/Wr command to the same bank.
Row Precharge Time (tRP) (N/A/10 CLK)
This item specifies Row precharge to Active or Auto-Refresh of the same bank.
RAS# Active Time (tRAS) (N/A/24 CLK)
This item specifies the RAS# active time.
SB Spread Spectrum (Enabled)
This item enables or disables the SB Clock Spread Spectrum.
Chipset M.I.B III
Auto
Auto
Auto
None
N/A
N/A
N/A
N/A
N/A
(DDR-1333/667Mhz)
1 T
9 CLK
9 CLK
10 CLK
24 CLK
Enabled
Disabled
Disabled
A75F2-M2 USER MANUAL
Boot Security
Core Clock multiplier
 : Select Screen

/Click: Select Item
Enter/Dbl Click : Select
+/- : Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC/Right Click: Exit
Exit
43