Crown SST-MX Reference Manual page 7

SST Modules
Bridge-Mono Mode
Standard bridge-mono-mode output
confi guration (shown in Figure 2.4)
routes the signal in the following
manner: low-frequency signal from
the amplifi er's Channel 1 input is
sent to the Channel 1 barrier block
output; high-frequency signal from
Channel 1 input is sent to the local
(amplifi ed) Channel 1 output.
Figure 2.4 Typical Bridge-Mono confi guration using Crown SST-compatible
Reference Manual
amplifi er and the SST-MX crossover module.
Note: Only the Channel 1 audio
signal is required to drive the ampli-
fi er during mono operation. If you
are using the SST-MX module with
the amplifi er in mono mode, be sure
to turn your Channel 2 level controls
all the way down.
Page 7