Table of Contents
Advertisement
SST Modules
Bridge-Mono Mode
For standard bridge-mono-mode
output wiring, connect your system
components as shown in Figure
3.4. This confi guration routes the
signals in the following manner:
low-frequency signals from the host
amplifi er are sent to the male XLR
output; high-frequency signal from
the host amplifi er's Channel 1 input
are sent to the local (amplified)
Channel 1 output.
Figure 3.4 Typical Bridge-Mono Confi guration Using the SST-SX
Reference Manual
Note: Only the Channel 1 audio
signals are required to drive the
amplifi er during mono operation. If
you are using the SST-SX module with
a Crown SST-compatible amplifi er
in mono mode, be sure to turn your
Channel 2 level control all the way
down.
Crossover Module
Page 11
Advertisement
Table of Contents
