Whirlpool 30" ELECTRIC MODULARDOWNDRAFT COOKTOP Service Manual page 29

4. Remove the five control knobs from the
control shafts.
5. Remove the indicated torx screw and the
metal insert from each of the the controls
and remove the control panel.
CONTROL
KNOB
TORX
SCREW
METAL
INSERT
CONTROL
PANEL
4 SCREWS
AT THIS LOCATION
BURNER BOX
6.
7.
REASSEMBLY NOTE: When you install the
control cover, first secure the left mounting
hole of each element control to the cover with
a short torx screw. Make sure that you align
the right mounting holes after you tighten the
screws so that you can install the longer torx
screws later. Also use two short torx screws
to secure the fan control to the control cover.
Position the fan control with the flatted shaft
facing the front.
COOKTOP
4 SCREWS
AT THIS LOCATION
3-5
Cooking Products Service Manual
Original April, 1996
© 1996 Whirlpool Corporation
Remove the four hex-head screws from
the control cover.
HEX SCREWS (4)
Remove the 10-screws shown in the illus-
tration and lift the top off the burner box.
4321972
Page 3-5
CONTROL
COVER