Fault Finding - Atco Balmoral Operating Instructions Manual

EURO • Printed in England • BA F016 L69 830 • Balmoral • U4 • OSW 09/01
F016 L69 830 - Buch Seite 6 Freitag, 21. September 2001 2:04 14
The following table gives checks and actions that you can perform if your machine does not operate cor-
rectly. If these do not identify/remedy the problem, contact an ATCO-QUALCAST Approved Service Agent.
Warning: Switch off, remove spark plug cap before investigating fault.
Symptom
Mower leaves a ragged
finish
Engine will not start
Engine stops
Engine does not stop
Cutting cylinder does not
rotate
Land drive does not
engage
Excessive vibration/noise
F016 L69 761 • TMS • 29.09.00

Fault Finding

Possible Cause
Cutter not correctly adjusted
Engine is flooded
Spark plug lead not connected
Spark plug dirty
No petrol
Engine speed too low for conditions
Cutting cylinder obstructed
Throttle cable not correctly adjusted. Stop engine by removing spark plug
Incorrect adjustment
Incorrect adjustment/cable
damaged
Blade(s) or/and cylinder bearing
damaged
Engine fault
English
Remedy
Adjust the cutter
Leave for 10 – 15 minutes
Reconnect
See engine maintenance manual
Refill tank
Move throttle
Turn off engine and clear obstruction
lead and refer to the engine mainte-
nance manual.
Contact an ATCO-QUALCAST
Approved Service Agent
Adjust cable
Contact an ATCO-QUALCAST
Approved Service Agent
Contact an ATCO-QUALCAST
Approved Service Agent
See engine maintenance manual
- 6