Data Setup - Samsung SCX-4824XBH Service Manual

4.1.5.3 Data Setup

SEND LEVEL
You can set the level of the transmission signal. Typically, the Tx level should be under -12 dBm.
arbitrarily.
DIAL MODE
This function can choose dial method.
*Default : Dial(Dial/Pulse)
MODEM SPEED
You can set the maximum modem speed.
Communication is done with modem speed automatically set at lower speed when communicating with a
slower speed modem since communication is done on the standard of the side where modem speed is low
for transmission/reception. It is best set 33.6Kbps as default setting.
ERROR RATE
This ensures that the error rate remains below the set value.
You can select the rate between 5% and 10%.
CLEAR ALL MEMORY
The function resets the system to factory default settings.
This function is used to reset the system to the initial value when the product is functioning abnormally. All the
values are returned to the default values, and all the information, which was set by the user, will be erased.
< Method >
2. Push the OK button.
3. Select you country. (There are four country groups. Refer to the table below.)
4. Push the OK button then it will clear all memory.
NOTICE : Always perform a memory clear after replacing the main board. Otherwise, the system may not
operate properly.
Country Group
Country
Service Manual
Alignment & Troubleshooting
USA/Canada
USA/Canada UK
Mexico Germany
Brazil France
Italy
Spain
Austria
Netherlands
Belgium
Portugal
Sweden
Norway
Denmark
Finland
Switzerland
Greece
Ireland
Turkey
UK Russia
Russia
India
Oman
Poland
Bangladesh
Kuwait
Moroco
Algeria
Pakistan
UAE
Bahrain
Srilanka
Saudi Arabia
Chile
Peru
Argentina
Romania
Bulgaria
Czech
4-13
Southafrica
South Africa
Samsung Electronics