Equipment Setup - Antunes, AJ Roundup VCT-20 Owner's Manual

VERTICAL CONTACT TOASTER
IMPORTANT: Make sure heat shield assy. is activat-
ing (depressing) the conveyor interlock switch (see
Figure 4). The conveyors will not rotate unless the
heat shield is in place and interlock switch is
activated (depressed).
NOTE: Check the release sheet to make sure it is
not caught in the conveyor. Additional release
sheets can be obtained through your authorized
service agency under part no. 7000110 (3 pack) or
7000111 (10 pack).

Equipment Setup

When placing the toaster into service, pay attention to
the following guidelines.
• Make sure power to the unit is off and the toaster
is at room temperature.
• Do not block or cover any openings on the unit.
• Do not immerse cord or plug in water.
• Keep cord away from heated surfaces.
• Do not allow cord to hang over edge of table or
counter.
Connect the unit to the power supply. Refer to the
specification plate for the proper voltage.
Lay sheet on a flat surface
Fold over so ends meet
Figure 3. Folding Release Sheet
Heat Shield
Platen
Conveyor Cover
Figure 4. Installing Release Sheet
8
Press lightly with finger to
form crease
Release Sheet
Conveyor Interlock
Switch
Conveyor Cover
P/N 1010729 Rev. C 05/04