Viewing The Heat Pump And Reversing Valve Jumper Setting - Venstar T1700 Owner's Manual

Viewing the Heat Pump and
Reversing Valve Jumper Settings
Step~ 10 and 11 are 'Read Only' and may only be set with the
jumpers on the circuit board of the thermostat (see page 4.4 of
the Installation Instructions).
OFF
Note: Press the MODE
button momentarily
to
move through the
setup screens. Press
and hold the MODE
Press the MODE button repeatedly
button
to
move back-
, wards through the·
until this setup screen appears.
~
setup screens.
Setup
I"
1f • .•J
Press the MODE button. While holding
the MODE, press the PROGRAM
button to enter Setup screens.
ON = Heat Pump
operation
OFF
=
Gas Electric
operation
MODE.
MODE
PROGRAM
Press
Indicates that the
thermostat jumper
is set for an 0
reversing valve
(energize in cooling)
or a b reversing valve
(energize in heating).
Setup
,
la'
I I
I '
MODE
~
~
Press
PROGRAM
Press the PROGRAM button to leave the Setup screens. If no buttons are
~
pressed, the display will leave the setup screens after 30 seconds.
Page 10.2