Heat Pump Settings; Heat Pump Lockout - Enabled/Disabled; Heat Pump Lockout Outdoor Temp; Aux Heat Lockout Enabled/Disabled - Venstar COMMERCIAL T6800 ColorTouch Owner's Manual And Installation Instructions

Main Menu Buttons -
Installation Settings

Heat Pump Settings

Heat Pump Lockout - DISABLED
Heat Pump Lockout - ENABLED
Turns on Heat Pump Lockout.
HP Lockout Outdoor Temp
Heat Pump will not run below this temp. (0˚ - 75˚ F)
Aux Heat Lockout - DISABLED
Aux Heat Lockout - ENABLED
Turns on Aux Heat Lockout.

Aux Heat Lockout Temp

Aux Heat will not run above this temp. (0˚ - 75˚ F) GAS/EL or HP dip
switch must be set for HP and GAS or ELEC dip switch must be set for ELEC.

Sensor Settings

Control Sensor

When a remote sensor is connected to the thermostat, the user may choose
which sensor source is used to measure room temperature.
Thermostat sensor only
Wired Sensor only
Average remote/thermostat
Wired Sensor Use
The wired sensor may be used as follows:
Outdoor sensor
Remote Sensor
Supply Sensor
Return Sensor

Calibrate Sensors

The thermostat and wired sensor may be calibrated -7˚ to +7˚ F .
Settings
(Continued)
(65˚)
(65˚)
(thermostat)
(remote)
(0˚)
37
(Only available
when dip switch
is set for Heat
Pump operation.)
For Lockout
Temperatures:
A local outdoor
sensor connected to
the thermostat is
required.
Skyport supplied
outdoor temperature
will not work in place
of a local sensor.