Features For Recording; White Led Light; Night Alive - JVC LYT1196-001A Instructions Manual

SNAPSHOT
Power Switch
Lock Button
Recording Start/Stop
Button
NIGHT

White LED Light

White LED Light
White LED Light can be used when more light is needed
during recording or D.S.C. shooting in the dark place.
1
Press LIGHT to set the desired LED Light mode.
OFF: Always unlit.
ON: Always turns on the light (
AUTO: Turns on the light automatically when dark
( appears).
2
Press the Recording Start/Stop Button or SNAPSHOT
to start recording or D.S.C. shooting.
To deactivate the White LED Light
Press LIGHT again so that the White LED Light indicator
disappears.
NOTES:
Be careful not to point the LED Light directly to human
eyes.
If the light does not reach the subject even though the
White LED Light setting is "ON", the Night-Alive function will
be activated, and makes it possible to shoot the subject
brighter.
There is a difference in the brightness of the images shot
between the center area which is illuminated by the LED
Light and the surrounding areas (which will be darker).
Since subjects are shot at a reduced shutter speed when
the White LED Light setting is "ON", they will appear slightly
blurred.
LIGHT
appears).

FEATURES FOR RECORDING

Night Alive

Makes dark subjects or areas even brighter than they
would be under good natural lighting. Although the
recorded image is not grainy, it may look as if it is
strobing due to the slow shutter speed.
1
Set the Power Switch to "M" while pressing down the
Lock Button located on the switch.
2
Open the LCD monitor fully. (
3
Press NIGHT so that the Night-Alive indicator "
appears.
The shutter speed is automatically adjusted to provide up to
30 times sensitivity.
" " appears beside "
automatically adjusted.
To deactivate Night-Alive
Press NIGHT again so that the Night-Alive indicator
disappears.
NOTES:
During Night-Alive, the following functions or settings
cannot be activated and its indicator blinks or goes out:
• Some modes of "Program AE With Special Effects"
( pg. 30).
• "GAIN UP" in CAMERA Menu. (
• "DIS" in MANUAL Menu. (
During Night-Alive, it may be difficult to bring the camcorder
into focus. To prevent this, use of a tripod is recommended.
EN
pg. 12)
" while the shutter speed is being
pg. 26)
pg. 26)
29
"