Table of Contents
Advertisement
27
WIRELESS PROGRAMMING
Activate the opener only when door is in full view, free of obstruction and properly adjusted. No one
should enter or leave garage while door is in motion. Do not allow children to operate push button(s)
or remote(s). Do not allow children to play near the door.
NOTE: The remote controls supplied with your opener
are pre-programmed to your receiver in the factory. If
you purchase additional remote controls, you will
need to program them into your opener using the
steps below.
Fix the warning against entrapment label near the
wall control.
ADDING remotes using the learn button:
1. Press and hold down the remote button you wish to
program to the opener. The orange LED will flash
continuously to indicate it is receiving signal from the
remote.
2. Press and release the orange learn button on the
opener.
3. The courtesy light will flash once.
4. Ensure the door is clear of obstruction, then test the
remote.
Using the motion detecting control panel
(optional accessory):
1. Press and hold the button on the hand-held remote that
you wish to operate your garage door.
2. While holding the remote button, press and hold the
LIGHT button on the motion detecting control panel.
3. Continue holding both buttons while you press the push
bar on the motion detecting control panel (all three
buttons are held).
4. Release buttons when the opener light flashes. It has
learned the code. If the light bulb is not installed, one
click will be heard.
Now the opener will operate when the remote control push
button is pressed. If you release the remote control push
button before the opener light flashes, the opener will not
learn the code.
Deleting ALL remote control codes
NOTE: This deletes all remotes and codes.
• Press and hold the LEARN button until the orange
indicator light goes out (approximately 9 sec) .
28
INSTALLING THE CM128 WIRELESS WALL BUTTON
Disconnect power to the opener whilst installing this
accessory to prevent accidental activation.
Locate minimum 1.5m above the floor.
To install:
• Carefully pry open the CM128 and locate the two screws for mounting.
• Attach to the wall using the two screws and wall anchors provided if
mounting to a plaster wall. If using a recessed wall box do not use
anchors.
NOTE: Do not overtighten screws.
NOTE: The wall button supplied with your opener should be pre-
programmed by the factory. If adding a new wall button, program into
the opener before mounting the unit as detailed in section 27.
1
1
2
12
1
2
3
O
–
180 s
60 s
120 s
3
2
3
4
+
Advertisement
Table of Contents
